Deployment Guide

Usage Information
This command applies to all the VRRP congured interfaces on a system. When used with the vrrp delay
minimum CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload is 600 and the
vrrp delay minimum is 300:
When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up
and congured for VRRP.
When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300
seconds (5 minutes) to bring up VRRP on that interface.
Save the conguration and reload the system for the delay timers to take eect.
Related Command vrrp delay minimum — sets the delay time for VRRP initialization after a line card reboot.
vrrp-group
Assign a VRRP ID to an interface. You can congure up to 12 VRRP groups per interface.
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id Enter a number as the group ID. The range is from 1 to 255.
Defaults Not congured.
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The VRRP group only becomes active and sends VRRP packets when a virtual IP address is congured. When you
delete the virtual address, the VRRP group stops sending VRRP packets.
Related Command virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
VRRP for IPv6 Commands
The following commands apply to IPv6.
clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf instance]
Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group. The range is from 1 to 255.
vrf instance (OPTIONAL) Enter the name of a VRF instance (32 characters maximum) to clear the
counters of all IPv6 VRRP groups in the specied VRF.
1356 Virtual Router Redundancy Protocol (VRRP)