Deployment Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
priority
Specify a VRRP priority value for the VRRP group. The VRRP protocol uses this value during the MASTER election process.
Syntax
priority priority
To return to the default value, use the no priority command.
Parameters
priority Enter a number as the priority. Enter 255 only if the router’s virtual address is the same as
the interface’s primary IP address (that is, the router is the OWNER). The range is from 1
to 255. The default is 100.
Defaults 100
Command Modes VRRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To guarantee that a VRRP group becomes MASTER, congure the VRRP group’s virtual address with same IP
address as the interface’s primary IP address and change the priority of the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal to the interface’s primary IP
address, an error message appears.
NOTE: Conguring VRRP priority 255 on an interface on which DHCP Client is enabled is not
supported.
show cong
View the non-default VRRP conguration.
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group conguration
information, including defaults.
Command Modes VRRP
Supported Modes Full–Switch
Command History
Version Description
1350 Virtual Router Redundancy Protocol (VRRP)