Deployment Guide

NUM Status Q Ports
* 1 Inactive
2 Active M Te 1/2
M Te 1/0-2
3 Active M Po1(Te 1/3-4)
M Te 1/5
M Te 1/3
4 Active M Po1(Te 1/3-5)
M Te 1/6
M Te 1/4
5 Active M Po1(Te 1/5-6)
M Te 1/6
M Te 1/5
Dell#
vlan-stack dot1p-mapping
Map C-Tag dot1p values to an S-Tag dot1p value. You can separate the C-Tag values by commas and dashed ranges are permitted. Dynamic
mode CoS overrides any Layer 2 QoS conguration if there is conicts.
Syntax
vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
Parameters
c-tag-dot1p value Enter the keyword c-tag-dot1p then the customer dot1p value that is mapped to a
service provider do1p value. The range is from 0 to 5.
sp-tag-dot1p value Enter the keyword sp-tag-dot1p then the service provider dot1p value. The range is
from 0 to 5.
Defaults none
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
vlan-stack protocol-type
Dene the stackable VLAN tag protocol identier (TPID) for the outer VLAN tag (also called the VMAN tag). If you do not congure this
command, the system assigns the value 0x9100.
Syntax
vlan-stack protocol-type number
Parameters
number Enter the hexadecimal number as the stackable VLAN tag.
You may specify both bytes of the 2-byte S-Tag TPID. The range is from 0 to FFFF. The
default is 9100.
Defaults 0x9100
Command Modes CONFIGURATION
Supported Modes Full–Switch
VLAN Stacking 1325