Deployment Guide

ManualsBrandsDell ManualsAccess PlatformsFN IO Module

1291

count

(OPTIONAL) Enter the keyword count to count packets processed by the lter.

The range is from 3-10, Default range is 3.

unlimited

Enter the keyword unlimited to specify the unlimited number of keepalive probe packets.

Defaults Tunnel keepalive is disabled.

Command Modes INTERFACE TUNNEL

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Introduced on the MXL.

Usage Information

When congured, the system will send ICMP echo probe packets at the congured interval and expect a response

within the congured number of attempts, else the tunnel interface will be declared operational down.

tunnel allow-remote

Congure an IPv4 or IPv6 address or prex whose tunneled packets will be accepted for decapsulation. If no allow-remote entries are

congured, tunneled packets from any remote peer address will be accepted.

Syntax

tunnel allow-remote {ip-address | ipv6-address} [mask]

Use the no tunnel allow-remote command to delete a congured allow-remote entry. Any specied address/mask

values must match an existing entry for the delete to succeed. If the address and mask are not specied, this

command deletes all allow-remote entries.

Parameters

ip-address Enter the source IPv4 address in A.B.C.D format.

ipv6–address Enter the source IPv6 address in X:X:X:X::X format.

mask (OPTIONAL) Enter a network mask in /prex format (/x) or A.B.C.D to match a range of

remote addresses. The default mask is /32 for IPv4 addresses and /128 for IPv6

addresses, which match only the specied address.

Defaults If no tunnel allow remote is congured, all trac which is destined to tunnel source address will be decapsulated.