Deployment Guide
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6.(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage Information
This command is supported on the FN410S and the FN410T Aggregators.
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are renumbered, only that
specic unit is reset and comes up with the new unit number.
Example
Dell#stack-unit 5 renumber 4
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
Related Commands
• reload – reboots Dell Networking Operating System (OS).
• reset stack-unit – resets the designated stack member.
• show system – displays the current status of all stack members or a specic member.
Stacking Commands 1243