Deployment Guide
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command sets the counter polling interval for an interface.
Related Commands sow polling-interval (Global) — globally sets the polling interval.
sow sample-rate (Global)
Change the global default sampling rate.
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate command.
Parameters
value Enter the sampling rate value. The range is from 256 to 8388608 packets. Enter values in
powers of 2 only; for example, 4096, 8192, 16384, and so on. The default is 32768
packets.
Defaults 32768 packets
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Sample-rate is the average number of packets skipped before the sample is taken. This command changes the
global default sampling rate. You can congure an interface to use a dierent sampling rate than the global
sampling rate. If the value entered is not a correct power of 2, the command generates an error message with the
previous and next power of 2 value. Select one of these two packet numbers and re-enter the command.
Related Commands sow sample-rate (Interface) — changes the interface sampling rate.
sow sample-rate (Interface)
Change the interface default sampling rate.
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate command.
Parameters
value Enter the sampling rate value. The range is from 256 to 8388608 packets. Enter values in
powers of 2 only; for example, 4096, 8192, and 16384. The default is the Global default
sampling.
Defaults The Global default sampling.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
1194 sFlow