Deployment Guide

sow extended-switch enable
Enable packing information on a switch only.
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable] command.
Parameters
enable Enter the keyword enable to enable global extended information.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The Dell Networking OS version 7.8.1.0 and later enhances the sow implementation for real time trac analysis to
provide extended gateway information in cases where the destination IP addresses are learned by dierent routing
protocols and for cases where the destination is reachable over ECMP.
Related Commands
show sow — displays the sFlow conguration.
sow max-header-size extended
Set the maximum header size of a packet to 256 bytes.
Syntax
sflow max-header-size extended
To reset the maximum header size of a packet, use the[no] sflow max-header-size extended
command.
Parameters
extended Enter the keyword extended to copy 256 bytes from the sample packets to sFlow
datagram.
Defaults 128 bytes
Command Modes
CONFIGURATION
INTERFACE
Supported Modes Full–Switch Mode
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1192 sFlow