Deployment Guide

Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information The type may be auto, manual, or rollback. When set to auto, Dell Networking OS automatically denies access to
CONFIGURATION mode to all other users every time the user on the listed VTY line enters CONFIGURATION
mode. When set to manual, the user on the listed VTY line must explicitly set the lock each time before entering
CONFIGURATION mode. Rollback indicates that Dell Networking OS is in a rollback process. The line number
shown in the output can be used to send the messages to that session or release a lock on a VTY line.
Example
Dell#show configuration lock
Configure exclusively locked by the following line:
Line : vty 0
Line number : 2
User : admin
Type : AUTO
State : LOCKED
Ip address : 10.11.9.97
Dell#
show cpu-trac-stats
Display the CPU trac statistics.
Syntax
show cpu-traffic-stats [port number | all]
Parameters
port number (OPTIONAL) Enter the port number to display trac statistics on that port only. The
range is from 1 to 1568.
all (OPTIONAL) Enter the keyword all to display trac statistics on all the interfaces
receiving trac, sorted based on the trac.
Defaults all
Command Modes EXEC
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information Trac statistics are sorted on a per-interface basis; the interface receiving the most trac is displayed rst. All
CPU and port information is displayed unless a specic port or CPU is specied. Trac information is displayed for
router ports only; not for management interfaces. The trac statistics are collected only after the debug cpu-
traffic-stats command is executed; not from the system bootup.
NOTE: After debugging is complete, use the no debug cpu-traffic-stats command to shut o
trac statistics collection.
Example
Dell#show cpu-traffic-stats
Processor : CP
--------------
110 Control and Monitoring