Deployment Guide

override Enter the keyword override to override the BSR updates with static RP. The override

takes eect immediately during enable/disable.

NOTE: This option is applicable to multicast group range.

Defaults none

Command Modes CONFIGURATION

Supported Modes Full—Swtich

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The RP addresses are stored in the order in which they are entered. RP addresses learned via BSR take priority

over static RP addresses.

Without the override option, the BSR-advertised RPs updates take precedence over the statically congured RPs.

ipv6 pim rp-candidate

Specify an interface as an RP candidate.

Syntax

ipv6 pim rp-candidate interface [priority-value]

Parameters

interface Enter the following keywords and slot/port or number information:

• For a Loopback interface, enter the keyword loopback then a number from 0 to

16383.

• For a Port Channel interface, enter the keywords port-channel then a number.

•

For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then

the slot/port information.

• For a VLAN, enter the keyword vlan then a number from 1 to 4094.

priority-value (OPTIONAL) Enter a number as the priority of this RP Candidate, which is included in the

Candidate-RP-Advertisements. The range is 0 (highest) to 255 (lowest).