Concept Guide

Example of the show ip dhcp lease Command
Dell# show ip dhcp
Interface Lease-IP Def-Router ServerId State Lease Obtnd At Lease Expires At
========= ======== ========= ======== ===== ============== ================ Ma
0/0
0.0.0.0/0 0.0.0.0 0.0.0.0 INIT -----NA----- ----NA----
Vl 1 10.1.1.254/24 0.0.0.0 10.1.1.1 BOUND 08-26-2011 04:33:39 08-27-2011 04:33:39
Renew Time Rebind Time
========== ========
----NA---- ----NA----
08-26-2011 16:21:50 08-27-2011 01:33:39
Conguring DHCP relay source interface
The following section explains how to congure global and interface level DHCP relay source IPv4 or IPv6 conguration to forward all the
DHCP packets from the DHCP client to DHCP server through the congured source interface. This feature is applicable only for L3
interface with relay conguration and L3 DHCP snooping enabled VLANs.
NOTE: The DHCP relay source interface conguration is supported in Full-Switch mode only.
Global DHCP relay source IPv4 or IPv6 conguration
You can congure global DHCP relay source IPv4 or IPv6 conguration using the command {ip | ipv6} dhcp-relay source-
interface interface command in the CONFIGURATION mode. DHCP relay uses the IPv4 or IPv6 global source address of the
congured interface for relaying packets to the DHCP server. For example, if you congure DHCP relay source interface as a loopback
interface, the DHCP relay uses the congured loopback interface to forward the packets to the DHCP server using the congured IPv4 or
IPv6 address. The source interface can be a VLAN, LAG, physical and loopback interfaces.
• Specify the type of an interface and interface-number that should be used as a DHCP relay source interface.
CONFIGURATION mode
{ip | ipv6} dhcp relay source-interface interface
Example conguration of global DHCP relay source IPv4 or IPv6 interface
Following is the sample conguration to congure loopback interface with IPv4 and IPv6 address in CONFIGURATION MODE.
Dell(conf)# interface loopback 1
Dell(conf-if-lo-1)# ip vrf forwarding vrf1
Dell(conf-if-lo-1)# ip address 1.1.1.1/32
Dell(conf-if-lo-1)# ipv6 address 1::1/128
Dell(conf-if-lo-1)# no shutdown
To congure the loopback interface as IPv4 or IPv6 DHCP relay source interface, enter the following commands in the CONFIGURATION
MODE.
Dell(conf)# ip dhcp relay source-interface loopback 1
Dell(conf)# ipv6 dhcp relay source-interface loopback 1
When you congure the above commands in the CONFIGURATION MODE, it will congure the loopback interface as the DHCP relay
source interface for forwarding the DHCP packets from DHCP client to server. When this command is congured in the CONFIGURATION
mode level, it is applied globally. So, all the DHCP packets will be relayed or forwarded through the congured L3 interface (loopback 1)
using the IPv4 (1.1.1.1/32) and IPv6 addresses (1::1/128) of the loopback conguration.
284
Dynamic Host Conguration Protocol (DHCP)