CLI Guide
Usage Information
The time interval between hello packets must be the same for routers in a network.
ipv6 ospf priority
To determine the Designated Router for the OSPFv3 network, set the priority of the interface.
Syntax
ipv6 ospf priority number
To return to the default time interval, use the no ipv6 ospf priority command.
Parameters
number
Enter the number as the priority. The range is from 1 to 255.
Defaults 1
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Setting a priority of 0 makes the router ineligible for election as a Designated Router or Backup Designated Router.
Use this command for interfaces connected to multi-access networks, not point-to-point networks.
ipv6 router ospf
Enable OSPF for IPv6 router conguration.
Syntax
ipv6 router ospf process-id
To exit OSPF for IPv6, use the no ipv6 router ospf process-id command.
Parameters
process-id
Enter the process identication number. The range is from 1 to 65535.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Open Shortest Path First (OSPFv2 and OSPFv3) 973