CLI Guide

Command Modes ROUTER OSPFv3
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
OSPFv3 graceful restart supports planned-only and/or unplanned-only restarts. The default is support for both
planned and unplanned restarts.
• A planned restart occurs when you enter the redundancy force-failover rpm command to force the
primary RPM to switch to the backup RPM. During a planned restart, OSPF sends out a Type-11 Grace LSA
before the system switches over to the backup RPM.
• An unplanned restart occurs when an unplanned event causes the active RPM to switch to the backup RPM,
such as when an active process crashes, the active RPM is removed, or a power failure happens. During an
unplanned restart, OSPF sends out a Grace LSA when the backup RPM comes online.
By default, both planned and unplanned restarts trigger an OSPFv3 graceful restart. Selecting one or the other
mode restricts OSPFv3 to the single selected mode.
ipv6 ospf area
Enable IPv6 OSPF on an interface.
Syntax
ipv6 ospf process id area area id
To disable OSPFv6 routing for an interface, use the no ipv6 ospf process-id area area-id command.
Parameters
process-id Enter the process identication number.
area area-id Specify the OSPF area. The range is from 0 to 65535.
Defaults none
Command Modes INTERFACE
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ipv6 ospf authentication
Enable IPv6 OSPF on an interface.
Syntax
ipv6 ospf authentication {null | ipsec spi number {MD5 | SHA1} [key-encryption-
type] key}}
Open Shortest Path First (OSPFv2 and OSPFv3) 967