CLI Guide

enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Syntax
enable optic-info-update interval seconds
To disable optical power information updates, use the no enable optic-info-update interval
command.
Parameters
interval seconds Enter the keyword interval then the polling interval in seconds. The range is from 120
to 6000 seconds. The default is 300 seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Replaces the enable xfp-power-updates command.
Usage Information To enable polling and to congure the polling frequency, use this command.
enable secure
Creates congurable Full–Switch mode where Chassis Management Controller (CMC) access to FN IOM is bypassed for the elements
critical to the security certications.
Syntax
enable secure
To disable the secure mode, use no enable secure command.
Parameters None
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL.
end
Return to EXEC Privilege mode from other command modes (for example, CONFIGURATION mode).
Syntax
end
Command Modes
• CONFIGURATION
• LINE
90 Control and Monitoring