CLI Guide

NPIV Proxy Gateway

The N-port identier virtualization (NPIV) Proxy Gateway (NPG) feature provides FCoE-FC bridging capability on the FN IOM with the FC

Flex IO module switch, allowing server CNAs to communicate with SAN fabrics over the FN IOMwith the FC Flex IO module.

To congure the FN I/OM with the FC Flex IO module to operate as an NPIV proxy gateway, use the following commands:

Topics:

• dcb-map

• description (for FCoE maps)

• fabric-id vlan

• fcf-priority

• fc-map

• fcoe-map

• feature fc

• fka-adv-period

• keepalive

• show fcoe-map

• show fc sw

• show interfaces status

• show npiv devices

• show qos dcb-map

• show running-cong fcoe-map

dcb-map

Create a DCB map to congure priority ow control (PFC) and enhanced transmission selection (ETS) on Ethernet ports that support

converged Ethernet trac. Apply the DCB map to an Ethernet interface.

Syntax

dcb-map map-name

Parameters

map-name Enter a DCB map name. The maximum number of alphanumeric characters is 32.

Defaults None. .

Command Modes CONFIGURATION

INTERFACE

Supported Modes Programmable-Mux (PMUX)

Full–Switch

890 NPIV Proxy Gateway