CLI Guide

tc-ush-standard
Enable the MAC address ushing after receiving every topology change notication.
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information By default, the sytem implements an optimized ush mechanism for MSTP. This mechanism helps in ushing the
MAC addresses only when necessary (and less often) allowing for faster convergence during topology changes.
However, if a standards-based ush mechanism is needed, this knob command can be turned on to enable
ushing MAC addresses after receiving every topology change notication.
Multiple Spanning Tree Protocol (MSTP) 877