CLI Guide

Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Because the default establishes Level 1 and Level 2 adjacencies, you do not need to congure this command.
Routers in an IS-IS system must be congured as a Level 1-only, Level 1-2, or Level 2-only system.
Only congure interfaces as Level 1 or Level 2 on routers that are between areas (for example, a Level 1-2 router)
to prevent the software from sending unused hello packets and wasting bandwidth.
isis csnp-interval
Congure the IS-IS complete sequence number PDU (CSNP) interval on an interface.
Syntax
isis csnp-interval seconds [level-1 | level-2]
To return to the default values, use the no isis csnp-interval [seconds] [level-1 | level-2]
command.
Parameters
seconds Interval of transmission time between CSNPs on multi-access networks for the
designated intermediate system. The range is from 0 to 65535. The default is 10.
level-1 (OPTIONAL) Independently congures the interval of time between transmission of
CSNPs for Level 1.
level-2 (OPTIONAL) Independently congures the interval of time between transmission of
CSNPs for Level 2.
Defaults seconds = 10; level-1 (if not otherwise specied)
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The default values of this command are typically satisfactory transmission times for a specic interface on a
designated intermediate system. To maintain database synchronization, the designated routers send CSNPs.
You can congure Level 1 and Level 2 CSNP intervals independently.
isis csnp-interval
Congure the IS-IS complete sequence number PDU (CSNP) interval on an interface.
Syntax
isis csnp-interval seconds [level-1 | level-2]
To return to the default values, use the no isis csnp-interval [seconds] [level-1 | level-2]
command.
774 Intermediate System to Intermediate System (IS-IS)