CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To congure a shortcut name that you can use instead of entering a long string of numbers associated with an
NSAP address, use this command.
Related Commands hostname dynamic — enables dynamic learning of host names from routers in the domain and allows the routers
to advertise the host names in LSPs.
debug isis
Enable debugging for all IS-IS operations.
Syntax
debug isis
To disable debugging of IS-IS, use the no debug isis command.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Entering debug isis enables all debugging parameters.
To display all debugging information in one output, use this command. To turn o debugging, you normally enter
separate no forms of each command. To disable all debug messages for IS-IS at once, enter the no debug isis
command.
debug isis adj-packets
Enable debugging on adjacency-related activity such as hello packets that are sent and received on IS-IS adjacencies.
Syntax
debug isis adj-packets [interface]
To turn o debugging, use the no debug isis adj-packets [interface] command.
Parameters
interface (OPTIONAL) Identies the interface type slot/port as one of the following:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Command Modes EXEC Privilege
760 Intermediate System to Intermediate System (IS-IS)