CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information After you congure a peer group as passive, you must assign it a subnet using the neighbor subnet command.
Related Commands neighbor subnet — assigns a subnet to a dynamically congured BGP neighbor.
neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
Syntax
neighbor {ipv6-address | peer-group-name} remote-as number
To delete a remote AS entry, use the no neighbor {ipv6-address | peer-group-name} remote-as
number command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
peer-group-name Enter a text string up to 16 characters long as the name of the peer group.
number Enter a number of the AS. The range is from 1 to 65535.
Defaults Not congured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If the number parameter is the same as the AS number used in the router bgp command, the remote AS entry
in the neighbor is considered an internal BGP peer entry.
This command creates a peer and the newly created peer is disabled (shutdown).
Related Commands router bgp — enters the ROUTER BGP mode and congure routes in an AS.
neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
Syntax
neighbor {ipv6-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ipv6-address | peer-group-name} remove-
private-as command.
698 IPv6 Border Gateway Protocol (IPv6 BGP)