CLI Guide

IPv6 Access Control Lists (IPv6 ACLs)

IPv6 ACLs and IPv6 Route Map commands are supported on Dell Networking switch.

NOTE: For IPv4 ACL commands, refer to the Access Control Lists (ACL) chapter.

Important Points to Remember

• Certain platforms require manual CAM usage space allotment. For more information, refer to the cam-acl (Conguration) command.

• Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.

• Reference to an empty ACL permits any trac.

• ACLs are not applied to self-originated trac (for example, Control Protocol trac not aected by IPv6 ACL because the routed bit is

not set for Control Protocol trac and for egress ACLs the routed bit must be set).

• You can use the same access list name for both IPv4 and IPv6 ACLs.

• You can apply both IPv4 and IPv6 ACLs on an interface at the same time.

• You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).

• Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.

• Because the prex mask is specied in /x format in IPv6 ACLs, inverse mask is not supported.

IPv6 ACL Commands

The following commands congure IPv6 ACLs.

cam-acl

Allocate space for IPv6 ACLs.

Syntax

cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos 1-10 l2qos

1-10}

Parameters

default Use the default CAM prole settings, and set the CAM as follows:

• L3 ACL (ipv4acl): 6

• L2 ACL(l2acl): 5

• IPv6 L3 ACL (ipv6acl): 0

• L3 QoS (ipv4qos): 1

• L2 QoS (l2qos): 1

l2acl 1-10 ipv4acl

1-10 ipv6acl 0-10

Allocate space to support IPv6 ACLs. Enter all of the proles and a range. Enter the CAM

prole name then the amount to be allotted. The total space allocated must equal 13. The

ipv6acl range must be a factor of 2.

636 IPv6 Access Control Lists (IPv6 ACLs)