CLI Guide
along the path because the DNS server maps the loopback IP address to the hostname and does not translate the
IP address of every interface of the switch to the hostname.
Example
Dell(conf)#ipv6 icmp source-interface tengigabitethernet 0/1
Dell(conf)#
ip max-frag-count
Set the maximum number of fragments allowed in one packet for packet re-assembly.
Syntax
ip max-frag-count count
To place no limit on the number of fragments allowed, use the no ip max-frag-count command.
Parameters
count Enter a number for the number of fragments allowed for re-assembly. The range is from 2
to 256.
Defaults No limit is set on number of fragments allowed.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To avoid denial of service (DOS) attacks, keep the number of fragments allowed for re-assembly low.
ip name-server
Enter up to six IPv4 addresses of name servers. The order you enter the addresses determines the order of their use.
Syntax
ip name-server ipv4-address [ipv4-address2...ipv4-address6]
To remove a name server, use the no ip name-server ip-address command.
Parameters
ipv4-address Enter the IPv4 address, in dotted decimal format, of the name server to be used.
ipv4-address2...
ipv4-address6
(OPTIONAL) Enter up ve more IPv4 addresses, in dotted decimal format, of name
servers to be used. Separate the addresses with a space.
Defaults No name servers are congured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
IPv4 Routing 607