CLI Guide

• ip route
• ip source-route
• ip tcp initial-time
• show ip tcp initial-time
• ip unreachables
• management route
• show arp
• show arp retries
• show hosts
• show ip cam stack-unit
• show ip b stack-unit
• show ip interface
• show ip management-route
• show ip multicast-cam stack-unit
• show ip protocols
• show ip route
• show ip route list
• show ip route summary
• show ip trac
• show tcp statistics
arp
To associate an IP address with a multicast MAC address in the switch when you congure multicast mode of the network load balancing
(NLB), use the address resolution protocol (ARP).
Syntax
arp ip-address multicast-mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
ip-address Enter an IP address in dotted decimal format.
multicast-mac-
address
Enter a 48–bit hexadecimal address in MAC address in nn:nn:nn:nn:nn:nn format for the
static MAC address to be used to switch multicast trac..
interface (OPTIONAL) Enter any of the following keywords and slot/port or number information:
• For the Management interface, enter the keyword ManagementEthernet then the
slot/port information. The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• The interface specied here must be one of the interfaces congured using the
{output-range | output} interface option with the mac-address-
table static command.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
IPv4 Routing 591