CLI Guide

Defaults none
Parameters
description Enter a text string description to identify the VLAN (80 characters maximum).
Command Modes INTERFACE
Supported Modes Standalone Mode
Usasge Information The auto vlan command adds the port as untagged to default vlan and tagged to all other 4094 VLAN.
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
clear mac-address-table dynamic
Clear the MAC address table of all MAC addresses learned dynamically.
Syntax
clear mac-address-table dynamic {interface tengigabitethernet slot/port-id}
Parameters
interface Enter the keyword interface range and one of the interfaces — slot/port, port-
channel or VLAN number. Select the range of interfaces for bulk conguration. You can
enter up to six comma separated ranges-spaces are not required between the commas.
Comma-separated ranges can include VLANs, port-channels and physical interfaces.
Slot/Port information must contain a space before and after the dash. For example,
interface range tengigabitethernet 0/1 - 5 is valid; interface range tengigabitethernet
0/1-5 is not valid.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
default vlan-id
Set the default VLAN ID.
Syntax
default vlan-id <vlan-id>
To reset the default VLAN ID, use the no default vlan-id command.
Defaults none
Interfaces 579