CLI Guide
Example
Dell(conf-if-range-te-0/6)#show range
interface tengigabitethernet 0/6
Dell(conf-if-range-te-0/6)#
Related Commands
interface — congures a physical interface on the switch.
show ip interface — displays Layer 3 information about the interfaces.
show interfaces — displays information on a specic physical interface or virtual interface.
shutdown
Disable an interface.
Syntax
shutdown
To activate an interface, use the no shutdown command.
Defaults The interface is disabled.
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
The shutdown command marks a physical interface as unavailable for trac. To discover if an interface is
disabled, use the show ip interface command. Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes dierent behavior. When a VLAN is disabled, the Layer 3 functions
within that VLAN are disabled. Layer 2 trac continues to ow. Entering the shutdown command on a port
channel disables all trac on the port channel and the individual interfaces within the port channel. To enable a
port channel, you must enter no shutdown on the port channel interface and at least one interface within that
port channel.
The shutdown and description commands are the only commands that you can congure on an interface
that is a member of a port channel.
Related Commands
vlan tagged —Test the condition of copper cables on 100/1000/10G Base-T modules.
interface vlan — Creates a VLAN.
show ip interface — Displays the interface routing status. Add the keyword brief to display a table of interfaces
and their status.
Interfaces 563