CLI Guide

Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
unit-number Enter the stack unit’s ID number. The range is from 0 to 5.
NOTE: This command also enables you to view information corresponding to a range of ports.
• You can specify multiple ports as slot/port-range. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show interfaces
interface-type 1/1 - 4.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the interface congurations
corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#sh interfaces status
Port Description Status Speed Duplex Vlan
Te 2/1 Down Auto Auto --
Te 2/2 Down Auto Auto --
Te 2/3 Down Auto Auto --
Te 2/4 Down Auto Auto --
Te 2/5 Down Auto Auto --
Te 2/6 Down Auto Auto --
Te 2/7 Down Auto Auto --
Te 2/8 Down Auto Auto --
Te 2/9 Up 10000 Mbit Full 1001
Te 2/10 Down Auto Auto --
Te 2/11 Up 10000 Mbit Full 1001
Te 2/12 Down Auto Auto --
Dell#
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE 802.1Q tag status
and VLAN membership.
Syntax
show interfaces switchport [interface | stack-unit unit-id ]
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
556 Interfaces