CLI Guide

Dell(conf-if-te-0/2)#int vlan 10
Dell(conf-if-vl-10)#int tengig 0/2
Dell(conf-if-vl-20)# untag tengig 0/2
Dell (conf-if-vl-20)#
Dell(conf)#do show interfaces switchport tengigabitethernet 3/2
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged,
V - VLT tagged
Name: TenGigabitEthernet 3/2
802.1QTagged: Hybrid
Vlan membership:
Q Vlans
U 20
T 10
Native VlanId: 20.
Dell(conf)#
Example
(uncongure the
hybrid port)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-vl-10)#no untagged tengig 0/2
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged tengig 0/2
Dell(conf-if-vl-20)#interface tengig 0/2
Dell(conf-if-te-0/2)#no portmode hybrid
Dell(conf-if-vl-20)#
Related Commands
show interfaces switchport — displays the conguration of switchport (Layer 2) interfaces on the switch.
vlan-stack trunk— species an interface as a trunk port to the Stackable VLAN network.
rate-interval
Congure the trac sampling interval on the selected interface.
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect trac data. The range is from 5 to 299
seconds.
NOTE: For 0 to 5 seconds, polling occurs every 5 seconds. For 6 to 10
seconds, polling occurs every 10 seconds. For any other value, polling occurs
every 15 seconds.
Defaults 299 seconds
Command Modes INTERFACE
Supported Modes Full–Switch
546 Interfaces