CLI Guide

source-module-id |
dest-ip | dest-ipv6 |
dest-port-id | dest-
module-id | protocol
| vlan | L4-source-
port | L4-dest-
port ]
• source-ipv6 — Use IPv6 src-ip eld in hash calculation
• source-port-id — Use src-port-id eld in hash calculation.
• source-module-id — Use src-module-id eld in hash calculation.
• dest-ip — Use IPv4 dest-ip eld in hash calculation
• dest-ipv6 — Use IPv6 dest-ip eld in hash calculation
• dest-port-id — Use dest-port-id eld in hash calculation.
• dest-module-id — Use dest-module-id eld in hash calculation.
• protocol — Use IPv4 protocol eld in hash calculation.
• vlan — Use vlan eld in hash calculation.
• L4-source-port — Use IPv4 L4-source-port eld in hash calculation.
• L4-dest-port — Use IPv4 L4-dest-port eld in hash calculation.
mac [source-mac |
source-port-id |
source-module-id |
dest-mac | dest-
port-id | dest-
module-id | vlan |
ethertype | source-
dest-mac ]
To use MAC key elds in hash computation, enter the keyword mac then one of the
parameters:
• source-mac — Use source-mac eld in hash calculation.
• source-port-id — Use src-port-id eld in hash calculation.
•
source-module-id — Use src-module-id eld in hash calculation.
• dest-mac — Use dest-mac eld in hash calculation.
• dest-port-id — Use dest-port-id eld in hash calculation.
• dest-module-id — Use dest-module-id eld in hash calculation.
• vlan — Use vlan eld in hash calculation .
• ethertype — Use Ethertype eld in hash calculation.
• source-dest-mac — Use SMAC and DMAC elds in hash calculation.
tunnel [ipv4-over-
ipv4 | ipv4-over-
gre-ipv4 | mac-in-
mac]
To use tunnel key elds in hash computation, enter the keyword tunnel then one of the
parameters:
• ipv4-over-ipv4 — Use ipv4-over-ipv4 eld in hash calculation.
• ipv4-over-gre-ipv4 — Use ipv4-over-gre-ipv4 eld in hash calculation.
•
mac-in-mac — Use mac-in-mac eld in hash calculation.
Defaults IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-port).
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
monitor interface
Monitor counters on a single interface or all interfaces on a line card. The screen is refreshed every ve seconds and the CLI prompt
disappears.
Syntax
monitor interface [interface]
540 Interfaces