CLI Guide

Defaults No description is dened.
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
• Spaces between characters are not preserved after entering this command unless you enclose the entire
description in quotation marks (“desc_text”).
• Entering a text string after the default vlan-id command overwrites any previous text string congured
as the description.
•
The show tdr and default vlan-id commands are the only commands that you can congure on an
interface that is a member of a port-channel.
• Use the show interfaces description command to display descriptions congured for each interface.
Related commands show interfaces description — Displays the description eld of interfaces.
owcontrol
Controls how the system responds to and generates 802.3x pause frames on 10G and 40Gig stack units.
Syntax
flowcontrol rx {off | on} tx {off | on} pause-threshold value [monitor session-
ID]
Parameters
rx on Enter the keywords rx on to process the received ow control frames on this port. This
is the default value for the receive side.
rx o Enter the keywords rx off to ignore the received ow control frames on this port.
tx on Enter the keywords tx on to send control frames from this port to the connected device
when a higher rate of trac is received. This is the default value on the send side.
tx o Enter the keywords tx off so that ow control frames are not sent from this port to
the connected device when a higher rate of trac is received.
pause-threshold Enter the buer threshold limit for generating PAUSE frames.
monitor Enter the keyword monitor then the session-ID to enable mirror ow control frames on
the interface. The range is from 0 to 65535.
Defaults
• rx off
• tx off
Command Modes INTERFACE
Supported Modes Programmable-Mux (PMUX)
528 Interfaces