CLI Guide

Example
Dell#clear counters
Clear counters on all interfaces [confirm]
clear dampening
Clear the dampening counters on all the interfaces or just the specied interface.
Syntax
clear dampening [interface]
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/port or number to clear
counters from a specied interface:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
Defaults Without an interface specied, the command clears all interface dampening counters.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
On the switch, after you enter the clear counters command and verify the results with the show
interfaces command, the line rate is not reset to 0.00%.
Example
Dell#clear dampening tengigabitethernet 1/2
Clear dampening counters on tengig 1/2 [confirm] y
Dell#
Related Commands
show interfaces dampening — displays interface dampening information.
dampening — congures dampening on an interface.
cx4-cable-length
Congure the length of the cable to be connected to the selected CX4 port.
Syntax
[no] cx4-cable-length {long | medium | short}
Parameters
long | medium |
short
Enter the keyword that matches the cable length to be used at the selected port:
• short = For 1-meter and 3-meter cable lengths.
• medium = For 5-meter cable length.
Interfaces 525