CLI Guide
Parameters
join Enter the keyword join then the number of milliseconds to congure the join time. The
range is from 100 to 147483647 milliseconds. The default is 200 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave Enter the keyword leave then the number of milliseconds to congure the leave time.
The range is from 100 to 2147483647 milliseconds. The default is 600 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave-all Enter the keywords leave-all then the number of milliseconds to congure the leave-
all time. The range is from 100 to 2147483647 milliseconds. The default is 1000
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Defaults As above.
Command Modes CONFIGURATION-GVRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
• Join Timer — Join messages announce the willingness to register some attributes with other participants.
For reliability, each GARP application entity sends a Join message twice and uses a join timer to set the
sending interval.
• Leave Timer — Leave announces the willingness to de-register with other participants. Together with Join,
Leave messages help GARP participants complete attribute reregistration and de-registration. The leave timer
starts after receipt of a leave message sent for de-registering some attribute information. If a Join message is
not received before the Leave time expires, the GARP application entity removes the attribute information as
requested.
• Leave All Timer — The Leave All timer starts when a GARP application entity starts. When this timer
expires, the entity sends a Leave-all message so that other entities can reregister their attribute
information. Then the Leave-all time begins again.
Related Commands show garp timers — displays the current GARP times.
gvrp enable
Enable GVRP on physical interfaces and LAGs.
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults Disabled.
Command Modes CONFIGURATION-INTERFACE
Supported Modes Full–Switch
506 GARP VLAN Registration (GVRP)