CLI Guide

netbios-node-type
Specify the NetBIOS node type for a Microsoft DHCP client. Dell Networking Operating System (OS) recommends specifying clients as
hybrid.
Syntax
netbios-node-type type
Parameters
type Enter the NETBIOS node type:
• Broadcast: Enter the keyword b-node.
• Hybrid: Enter the keyword h-node.
• Mixed: Enter the keyword m-node.
• Peer-to-peer: Enter the keyword p-node.
Defaults Hybrid
Command Modes DHCP <POOL>
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
network
Specify the range of addresses in an address pool.
Syntax
network network /prefix-length
Parameters
network/ prex-
length
Specify a range of addresses. Prex-length range is from 17 to 31.
Defaults none
Command Modes DHCP <POOL>
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
440 Dynamic Host Conguration Protocol