CLI Guide

dot1p6_group-num
dot1p7_group-num
Defaults None
Command Modes DCB MAP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O Aggregator.
Usage Information
PFC and ETS settings are not pre-congured on Ethernet ports. You must use the dcb-map command to
congure dierent groups of 802.1p priorities with PFC and ETS settings.
Using the priority-pgid command, you assign each 802.1p priority to one priority group. A priority group
consists of 802.1p priority values that are grouped together for similar bandwidth allocation and scheduling, and
that share latency and loss requirements. All 802.1p priorities mapped to the same queue must be in the same
priority group. For example, the
priority-pgid 0 0 0 1 2 4 4 4 command creates the following groups
of 802.1p priority trac:
• Priority group 0 contains trac with dot1p priorities 0, 1, and 2.
• Priority group 1 contains trac with dot1p priority 3.
• Priority group 2 contains trac with dot1p priority 4.
• Priority group 4 contains trac with dot1p priority 5, 6, and 7.
To remove a priority-pgid conguration from a DCB map, enter the no priority-pgid command.
Related Commands
priority-group bandwidth pfc— Congures the ETS bandwidth allocation and the PFC setting used to manage the
port trac in an 802.1p priority group.
qos-policy-output ets
To congure the ETS bandwidth allocation and scheduling for priority trac, create a QoS output policy.
Syntax
qos-policy-output policy-name ets
To remove the QoS output policy, use the no qos-policy-output ets command.
Parameters
policy-name Enter the policy name. The maximum is 32 characters.
Command Modes CONFIGURATION
Supported Modes All Modes
412 Data Center Bridging (DCB)