CLI Guide

* 63.114.8.34 0 18508 209 701 i
--More--
show ip bgp neighbors
Allows you to view the information BGP neighbors exchange.
Syntax
show ip bgp [ipv4 unicast] neighbors [ip-address [advertised-routes | dampened-
routes | detail | flap-statistics | routes | {received-routes [network
[network-mask]]} | {denied-routes [network [network-mask]]}]
Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view information only related to
ipv4 unicast routes.
ip-address (OPTIONAL) Enter the IP address of the neighbor to view only BGP information
exchanged with that neighbor.
advertised-routes (OPTIONAL) Enter the keywords advertised-routes to view only the routes the
neighbor sent.
dampened-routes (OPTIONAL) Enter the keywords dampened-routes to view information on dampened
routes from the BGP neighbor.
detail (OPTIONAL) Enter the keyword detail to view neighbor-specic internal information
for the IPv4 Unicast address family.
ap-statistics (OPTIONAL) Enter the keywords flap-statistics to view ap statistics on the
neighbor’s routes.
routes (OPTIONAL) Enter the keyword routes to view only the neighbor’s feasible routes.
received-routes
[network [network-
mask]
(OPTIONAL) Enter the keywords received-routes then either the network address
(in dotted decimal format) or the network mask (in slash prex format) to view all
information received from neighbors.
NOTE: Congure the neighbor soft-reconfiguration inbound
command prior to viewing all the information received from the neighbors.
denied-routes
[network [network-
mask]
(OPTIONAL) Enter the keywords denied-routes then either the network address (in
dotted decimal format) or the network mask (in slash prex format) to view all
information on routes denied via neighbor inbound lters.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
After a peer reset, the contents of the notication log messages is displayed in hex values for debugging.
The following describes the show ip bgp neighbors command shown in the following examples.
346 Border Gateway Protocol IPv4 (BGPv4)