CLI Guide

Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Although the system does not generate a route due to the backdoor cong, there is an option for injecting/
sourcing a local route in the presence of network backdoor cong on a learned route.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static} command.
Parameters
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static
Enter the keyword static to redistribute manually congured routes.
These routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name of an established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set metric
• set tag
If the route map is not congured, the default is deny (to drop all routes).
Defaults Not congured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
With the Dell Networking OS version 8.3.1.0 and later, you can use the redistribute command to advertise the
IGP cost as the MED on redistributed routes. When you set the route-map with metric-type internal and applied
outbound to an EBGP peer/peer-group, the advertised routes corresponding to those peer/peer-groups have the
IGP cost set as MED.
If you do not congure the default-metric command, in addition to the redistribute command, or there
is no route map to set the metric, the metric for redistributed static and connected is “0”.
To redistribute the default route (0.0.0.0/0), congure the neighbor default-originate command.
Border Gateway Protocol IPv4 (BGPv4) 329