CLI Guide

Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If you apply a route map to a BGP peer or neighbor with the neighbor default-originate command
congured, the software does not apply the set lters in the route map to that BGP peer or neighbor.
neighbor description
Assign a character string describing the neighbor or group of neighbors (peer group).
Syntax
neighbor {ip-address | peer-group-name} description text
To delete a description, use the no neighbor {ip-address | peer-group-name} description
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
text Enter a continuous text string up to 80 characters.
Defaults Not congured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
neighbor distribute-list
Distribute BGP information via an established prex list.
Syntax
neighbor {ip-address | peer-group-name} distribute-list prefix-list-name {in |
out}
To delete a neighbor distribution list, use the no neighbor {ip-address | peer-group-name}
distribute-list prefix-list-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the distribute list lter to all routers in the peer
group.
prex-list-name
Enter the name of an established prex list.
If the prex list is not congured, the default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound trac.
314 Border Gateway Protocol IPv4 (BGPv4)