CLI Guide

Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
bfd enable (Conguration)
Enable BFD on all interfaces.
Syntax
bfd enable
Disable BFD using the no bfd enable command.
Defaults BFD is disabled by default.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
bfd enable (Interface)
Enable BFD on an interface.
Syntax
bfd enable
Defaults BFD is enabled on all interfaces when you enable BFD from CONFIGURATION mode.
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
bfd interval
Specify non-default BFD session parameters beginning with the transmission interval.
Syntax
bfd interval interval min_rx min_rx multiplier value role {active | passive}
Parameters
interval milliseconds Enter the keywords interval to specify non-default BFD session parameters beginning
with the transmission interval. The range is from 50 to 1000. The default is 200.
274 Bidirectional Forwarding Detection (BFD)