CLI Guide

host ip-address Enter the keyword host then the IP address to specify a host IP address.
bit Enter a ag or combination of bits:
• ack: acknowledgement eld
• fin: nish (no more data from the user)
• psh: push function
• rst: reset the connection
• syn: synchronize sequence numbers
• urg: urgent eld
dscp Enter the keyword dscp to deny a packet based on the DSCP value. The range is from 0
to 63.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for the port parameter)
port port Enter the application layer port number. Enter two port numbers if you are using the
range logical operand. The range is from 0 to 65535.
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
destination Enter the IP address of the network or host to which the packets are sent.
mask Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when specied in
A.B.C.D format, may be either contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the lter processes.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry.
The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-
order numbers have a higher priority). If you do not use the keyword order, the ACLs
have the lowest order by default (
255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The threshold range is from 1 to 10 minutes.
172 Access Control Lists (ACL)