CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The Dell operating system supports one ingress and one egress IP ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed specications on entries allowed per
ACL, refer to your line card documentation.
Example
Dell(conf)#ip access-list standard TestList
Dell(config-std-nacl)#
Related Commands
ip access-list extended — creates an extended access list.
resequence access-list — Displays the current conguration.
permit (for Standard IP ACLs)
To permit packets from a specic source IP address to leave the switch, congure a lter.
Syntax
permit {source [mask]| any | host ip-address} [no-drop] [count [byte]] [dscp
value] [order] [fragments] [log [interval minutes] [threshold-in-msgs [count]]
[monitor]
To remove this lter, you have two choices:
• Use the no seq sequence-number command if you know the lter’s sequence number.
•
Use the no permit {source [mask] | any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the network from which the packet was
sent.
mask (OPTIONAL) Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when
specied in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the lter.
host ip-address Enter the keyword host then the IP address to specify a host IP address or hostname.
no-drop Enter the keywords no-drop to match only the forwarded packets.
count (OPTIONAL) Enter the keyword count to count packets processed by the lter.
bytes (OPTIONAL) Enter the keyword bytes to count bytes processed by the lter.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry.
The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-
order numbers have a higher priority). If you do not use the keyword order, the ACLs
have the lowest order by default (
255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
156 Access Control Lists (ACL)