CLI Guide

dot1x reauth-max
Congure the maximum number of times a port can reauthenticate before the port becomes unauthorized.
Syntax
dot1x reauth-max number
To return to the default, use the no dot1x reauth-max command.
Parameters
number Enter the permitted number of reauthentications. The range is from 1 to 10. The default is
2.
Defaults 2
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
dot1x server-timeout
Congure the amount of time after which exchanges with the server time-out.
Syntax
dot1x server-timeout seconds
To return to the default, use the no dot1x server-timeout command.
Parameters
seconds Enter a time-out value in seconds. The range is from 1 to 300, where 300 is
implementation dependant. The default is 30.
Defaults 30 seconds
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
When you congure the dot1x server-timeout value, take into account the communication medium used to
communicate with an authentication server and the number of RADIUS servers congured. Ideally, the dot1x
server-timeout
value (in seconds) is based on the congured RADIUS-server timeout and retransmit values
and calculated according to the following formula: dot1x server-timeout seconds > (radius-server
retransmit seconds + 1) * radius-server timeout seconds.
802.1X 141