CLI Guide

show vrrp ipv6
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the system returns No Active VRRP group.
Syntax
show vrrp ipv6 [vrid] [interface] [brief]
Parameters
vrid (OPTIONAL) Enter the virtual router identier for the VRRP group to view only that
group. The range is from 1 to 255.
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For SONET interfaces, enter the keyword sonet then the slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID range
is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the VRRP
groups.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show vrrp ipv6 command shown in the following example.
Line Beginning
with
Description
GigabitEthernet... Displays the Interface, the VRRP group ID, and the network address. If the interface is no
sending VRRP packets, 0.0.0.0 appears as the network address.
State: master... Displays the interface’s state:
• Na/If (not available).
• master (MASTER virtual router).
• backup (BACKUP virtual router).
the interface’s priority and the IP address of the MASTER.
Hold Down:... This line displays additional VRRP conguration information:
• Hold Down displays the hold down timer interval in seconds.
• Preempt displays TRUE if preempt is congured and FALSE if preempt is not
congured.
• AdvInt displays the Advertise Interval in seconds.
Virtual Router Redundancy Protocol (VRRP) 1357