CLI Guide
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Example
VLT ARP Statistics
----------------
ARP Tunnel Pkts sent:0
ARP Tunnel Pkts Rcvd:0
ARP-sync Pkts Sent:0
ARP-sync Pkts Rcvd:0
ARP Reg Request sent:19
ARP Reg Request rcvd:10
delay-restore abort-threshold
Increase the Boot Up timer to some value (>60 seconds).
Syntax
delay-restore abort-threshold <interval>
To remove use the no delay-restore abort-threshold command.
Defaults 60 seconds
Command Modes VLT DOMAIN
Supported Modes Full–Switch
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on Supported on the MXL 10/40GbE Switch IO Module.
Parameter
Enter the value (in seconds) to specify the time interval for delay restore timer to abort. This timer is applicable
only during reload/boot-up and not in other scenarios (example, ICL ap).
The range is from 1 to 1800 seconds.
Usage Information To abort VLT delay restore timer as the maximum threshold, the maximum time interval is applied to hold down ICL
peer-up in the start-up congurations during the reload.
1330 Virtual Link Trunking (VLT)