CLI Guide
Parameters
view-name Enter the name of the view (not to exceed 20 characters).
oid-tree Enter the OID sub tree for the view (not to exceed 20 characters).
included (OPTIONAL) Enter the keyword included to include the MIB family in the view.
excluded (OPTIONAL) Enter the keyword excluded to exclude the MIB family in the view.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The oid-tree variable is a full sub-tree starting from 1.3.6 and cannot specify the name of a sub-tree or a MIB.
The following Example congures a view named rview that allows access to all objects under 1.3.6.1.
Example
Dell#(conf) snmp-server view rview 1.3.6.1 included
Related Commands show running-cong — displays the SNMP running conguration.
snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status command.
Defaults Enabled.
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If the interface is expected to ap during normal usage, you could disable this command.
Syslog Commands
The following commands allow you to congure logging functions on all Dell Networking switches.
1218
Simple Network Management Protocol (SNMP) and Syslog