CLI Guide

Parameters
byte-count Enter one of the following values 8, 16, 24 or 32. Packet sizes are 8000 bytes, 16000
bytes, 32000 bytes, and 64000 bytes.
Defaults 8
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
snmp-server trap-source
Congure a specic interface as the source for SNMP trac.
Syntax
snmp-server trap-source interface
To disable sending traps out a specic interface, use the no snmp trap-source command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
Defaults The IP address assigned to the management interface is the default.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To enable this snmp-server trap-source command, congure an IP address on the interface and enable the
interface congured as an SNMP trap source.
Related Commands snmp-server community — sets the community string.
snmp-server user
Congure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address udp-port port-number} [1 |
2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv des56 | aes128–cfb}
1214 Simple Network Management Protocol (SNMP) and Syslog