CLI Guide

ManualsBrandsDell ManualsAccess PlatformsFN IO Module

1151

To delete a source interface, use the no ip tacacs source-interface command.

Parameters

interface Enter the following keywords and slot/port or number information:

• For a Port Channel interface, enter the keywords port-channel then a number.

The range is from 1 to 128.

• For a ten-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet

then the slot/port information.

•

For VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Defaults Not congured.

Command Modes CONFIGURATION

Supported Modes All Modes

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

tacacs-server host

Specify a TACACS+ host.

Syntax

tacacs-server host {hostname | ipv4-address | ipv6-address} [port number]

[timeout seconds] [key key]

Parameters

hostname Enter the name of the TACACS+ server host.

ipv4-address | ipv6-

address

Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of the TACACS+ server

host.

port number (OPTIONAL) Enter the keyword port then a number as the port to be used by the

TACACS+ server. The range is from zero (0) to 65535. The default is 49.

timeout seconds (OPTIONAL) Enter the keyword timeout then the number of seconds the switch waits

for a reply from the TACACS+ server. The range is from 0 to 1000. The default is 10

seconds.

key key

(OPTIONAL) Enter the keyword key then a string up to 42 characters long as the

authentication key. This authentication key must match the key specied in the tacacs-

server key

for the TACACS+ daemon.