CLI Guide

Defaults The ve pre-dened WRED proles. When you congure a new prole, the minimum and maximum threshold
defaults to predened wred_ge_g values.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Use the default pre-dened proles or congure your own prole. You cannot delete the pre-dened proles or
their default values. This command enables WRED conguration mode — (conf-wred).
dscp
Sets the number of specic DSCP values for a color map prole to yellow or red.
Syntax
dscp {yellow | red} [list-dscp-values]
To remove a color policy map prole, use the no dscp {yellow | red} [dscp-list] command.
Parameters
Yellow Enter the yellow keyword. Trac marked as yellow delivers trac to the egress queue
which either transmits the packet if it has available bandwidth or drops the packet due to
no ability to send.
Red Enter the red keyword. Trac marked as red is dropped.
dscp-list Enter a list of IP DSCP values. The dscp-list parameter species the full list of IP DSCP
value(s) for the specied color. Each DSCP value in a list is separate values by commas –
no spaces (1,2,3) or indicates a list of values separated by a hyphen (1-3). Range is 0 to
63.
Defaults None
Command Modes CONFIG-COLOR-MAP
Supported Modes Full–Switch
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the S6000-ON.
9.5.0.0 Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage Information If the specied color-map does not exist, the Diserv Manager (DSM) creates a color map and sets all the DSCP
values to green (low drop precedence).
1082 Quality of Service (QoS)