CLI Guide
Command Modes QOS-POLICY-OUT
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you apply rate-shape in QoS policy both on the Queue Level and in Aggregate mode, the queue-based
shaping occurs rst then aggregate rate shaping.
service-policy input
Apply an input policy map to the selected interface.
Syntax
service-policy input policy-map-name [layer2]
To remove the input policy map from the interface, use the no service-policy input policy-map-
name [layer2] command.
Parameters
policy-map-name Enter the name for the policy map in character format (16 characters maximum). You can
identify an existing policy map or name one that does not yet exist.
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map. The default is
Layer 3.
Defaults Layer 3
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information You can attach a single policy-map to one or more interfaces to specify the service-policy for those interfaces. A
policy map attached to an interface can be modied.
NOTE: The service-policy commands are not allowed on a port channel. The service-policy
input policy-map-name command and the service-class dynamic dot1p command are not
allowed simultaneously on an interface.
Related Commands policy-map-input — creates an input policy map.
1068 Quality of Service (QoS)