CLI Guide
Defaults Refer to Parameters.
Command Modes CONFIGURATION
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number. The range is from 0 to
4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The router with the largest value assigned to an interface becomes the designated router. If two interfaces contain
the same designated router priority value, the interface with the largest interface IP address becomes the
designated router.
ipv6 pim join-lter
Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the PIM-SM router from creating
state based on multicast source and/or group.
Syntax
ipv6 pim join-filter access-list
Parameters
access-list Enter the name of an extended access list.
in Enter the keyword in to apply the access list to inbound trac.
out Enter the keyword out to apply the access list to outbound trac.
Defaults none
Command Modes INTERFACE
1012 PIM-Sparse Mode (PIM-SM)