CLI Guide

Field Description
Incoming interface Displays the reverse path forwarding (RPF) interface towards the RP/ source.
RPF neighbor Displays the next hop from this interface towards the RP/source.
Outgoing interface
list:
Lists the interfaces that meet one of the following criteria:
• a directly connect member of the Group
• statically congured member of the Group
• received a (*,G) Join message
Example
Dell#show ip pim tib
PIM Multicast Routing Table
Flags:D- Dense, S- Sparse, C- Connected, L- Local, P- Pruned,
R- RP-bit set, F- Register flag, T- SPT-bit set, J- Join SPT,
M- MSDP created entry, A- Candidate for MSDP Advertisement,
K- Ack-Pending State
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(*, 226.1.1.1), uptime 01:29:19, expires 00:00:52, RP 10.211.2.1, flags: SCJ
Incoming interface: TenGigabitEthernet 0/2, RPF neighbor 10.211.1.2
Outgoing interface list:
TenGigabitEthernet 0/8
(*, 226.1.1.2), uptime 00:18:08, expires 00:00:52, RP 10.211.2.1, flags: SCJ
Incoming interface: TenGigabitEthernet 1/2, RPF neighbor 10.211.1.2
Outgoing interface list:
TenGigabitEthernet 0/8
(*, 226.1.1.3), uptime 00:18:08, expires 00:00:52, RP 10.211.2.1, flags: SCJ
Incoming interface: TenGigabitEthernet 1/2, RPF neighbor 10.211.1.2
Outgoing interface list:
TenGigabitEthernet 0/8
(*, 226.1.1.4), uptime 00:18:08, expires 00:00:52, RP 10.211.2.1, flags: SCJ
Incoming interface: TenGigabitEthernet 1/2, RPF neighbor 10.211.1.2
Outgoing interface list:
TenGigabitEthernet 0/8
show running-cong pim
Display the current conguration of PIM-SM snooping.
Syntax
show running-config pim
Command Modes EXEC Privilege
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
1010 PIM-Sparse Mode (PIM-SM)