CLI Guide

ip pim sparse-mode sg-expiry-timer

Enable expiry timers globally for all sources, or for a specic set of (S,G) pairs an access list denes.

Syntax

ip pim sparse-mode sg-expiry-timer seconds [access-list name]

To disable congured timers and return to default mode, use the no ip pim sparse-mode sg-expiry-

timer command.

Parameters

seconds Enter the number of seconds the S, G entries are retained. The range is from 211 to

86400.

access-list name (OPTIONAL) Enter the name of a previously congured Extended ACL to enable the

expiry time to specied S,G entries.

Defaults Disabled. The default expiry timer (with no times congured) is 210 sec.

Command Modes CONFIGURATION

Supported Modes Full—Swtich

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information This command congures an expiration timer for all S.G entries, unless they are assigned to an Extended ACL.

ip pim spt-threshold

To switch to the shortest path tree when the trac reaches the specied threshold value, congure the PIM router.

Syntax

ip pim spt-threshold value | infinity

To return to the default value, use the no ip pim spt-threshold command.

Parameters

value (OPTIONAL) Enter the trac value in kilobits per second. The default is 10 packets per

second. A value of zero (0) causes a switchover on the rst packet.

innity (OPTIONAL) Enter the keyword infinity to never switch to the source-tree.

Defaults Not congured.