Quick Start Manual

The installation script provides a summary of all the installation variables you have chosen up to this point. You

must confirm that the information is correct before continuing. Then, at the prompt, the script asks whether you

want to start the Fluid Cache service with the message: Would you like to start Fluid Cache

now? ('y' for yes | 'n' for no and exit install):

10. To start the Fluid Cache service, type y and press <Enter>.

11. To ensure that the product has started successfully, run the command: /opt/dell/fluidcache/bin/fldc

--status

This command returns a set of information similar to the following:

Fluid Cache Service

Cache size: 0 GiB

Status: ok

SSDs in Cache: 0

Disk being cached: 0

Write Back: unavailable

Cache ID: <any node>.example.com

License: node – limited to 4 nodes

License Status: valid

SSDs in cache No SSDs are configured in the cache

pool

Disks being cached No Disks are being cached

Fluid Cache for DAS is successfully installed. You must now configure Fluid Cache for DAS. See the topic

“Configuring And Managing Fluid Cache For DAS” in the

Dell Fluid Cache For DAS User's Guide

at dell.com/

support/manuals. If the installation was not successful, the following error message is displayed: bash: /opt/

dell/fluidcache/bin/fldc: No such file or directory

. To resolve the issue, see the topic

“Fluid Cache Installation Fails” in the

Dell Fluid Cache For DAS User's Guide

at dell.com/support/manuals.

Uninstalling Fluid Cache For DAS

Use Dell OpenManage Server Administrator or the fldc tool to disable caching on the back end disks.

1. To disable using fldc, at the prompt, run the command: fldc --disable --disk=<disk_name>

NOTE: Run this command for each configured disk.

2. Remove all cache devices from the cache pool. To remove a PCIe SSD, run the command: fldc --remove --

ssd=<ssd_name>

NOTE: Run this command for each configured disk.

3. Run the command: rpm -qa | grep DAS to get the Fluid Cache for DAS package name.

4. Use the rpm -e command to remove the Fluid Cache for DAS package from the server. For example, run the

command:

rpm –e <extract_package_name>

5. Optionally, you can remove the /opt/dell/fluidcache directory to remove all components of Fluid Cache for DAS from

your installation. At the prompt, run the command: rm -rf /opt/dell/fluidcache