Installation and Service Manual

Figure 55. Removing the BOSS S2 module
Next steps
1. Replace the BOSS S2 module.
Installing the BOSS S2 module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If required, remove the air shroud.
Steps
1. Install the BOSS S2 module into the BOSS module cage.
2. Using the Phillips #1 screwdriver, secure the BOSS S2 module on the BOSS module bay with the two screws.
Figure 56. Installing the BOSS S2 module
Installing and removing system components
63